Cambridge Audio BK10 Guida di Installazione

BK10A-BUS table-top keypadInstallation Guide

Avoid placing the keypad where there is line of sight to another keypad. In suchsituations both keypads may pick up the same commands from a remotecon

REAR PANEL CONNECTIONSSpeaker outputConnect to a pair of speakers with tworuns of standard high-quality speakercable. Speakers of at least 88dB SPLfor

The six LEDs indicate thevolume level of the BK10. The LEDsalso also display the source selectedwhen the source is changed and canalso show the status

Volume downPress to decrease the volume or other sound adjustment.Source select (left)Use this key to select the current active source.IR windowPoint

OPERATING INSTRUCTIONSVolume adjustmentVolume is adjusted using the volume up and volume down buttons on thekeypad or remote; this is indicated on the

Continuing to hold both buttons will light thefourth LED indicating that Balance adjust modehas been activated. In this mode pressing theVolume up/dow

Note: This feature is only available if the BK10 is part of a full Incognito multi-room system with one or two Local Input Modules (LM10) fitted.The l

Pressing the Select left or right buttons on thekeypad allows you to rotate through all six sourcesas default. However, it is possible to allow theadd

Input impedance 45 k ohmsFrequency response 20Hz – 20kHz +/- 1dBTHD <0.2% @ 1W, 20Hz – 20 kHzS/N ratio > 80 dB ‘A’ weightedVolume control rang

BK10 Table-top keypad Incognito table-top keypad 19 Cambridge Audio warrants this product to be free from defects in materials and workmanship(subject

2 Incognito table-top keypad

Incognito BK10 www.cambridge-audio.comPart No. AP19601/1

CONTENTSBK10 Table-top keypad Incognito table-top keypad 3Introduction...4Configurations...

4 Incognito table-top keypadThank you for purchasing this Cambridge Audio Incognito product. Incognito isa cost-effective, modular based multi-room s

BK10 Table-top keypad Incognito table-top keypad 5The BK10 can be used in two types of configurations:1. As an A-BUS Ready / Incognito Ready keypad at

In this configuration the keypad is connected directly to the amplifier/receiver.A power supply unit (Incognito PS5) is also required to power the one

BK10 Table-top keypad Incognito table-top keypad 7The BK10 comes with 10 metres of Cat5 connection cable, but an IncognitoCP20 cable pack (with 20 met

SpeakercableSpeakercablePS10AH10Cat-5/5e cableBK10 KP10 EUThe BK10 keypad can also be used as part of a full Incognito system, where it isplugged into

BK10 rearNote: When using a BK10 keypad with an AH10 hub, an Incognito PS10 powersupply unit MUST be used. Please consult the AH10 Incognito Multi-Roo