Cambridge Audio AH10 Guida di Installazione

KP10A-BUS keypadInstallation Guide

Cat5 to KP10 punch down connectorsA Cat-5 cable (terminated with an RJ45 jackplug) is used to connect the KP10 to an AH10hub or A-BUS Ready receiver.

Incognito A-BUS keypad 11Line-in/Line-outconnections on subwooferScreened audio cablePreampoutputconnectionson rear ofKP10Gain adjustThe maximum outp

12 Incognito KP10 The six LEDs indicate the function statusof the KP10. Listed below are each of thefunctions of the corresponding LEDs:Minimum volum

Incognito A-BUS keypad 13Standby/OnPress to switch the keypad between On and Standby mode. By pressing and holding theStandby button for about 2 seco

14 Incognito KP10 OPERATING INSTRUCTIONSImportant!As mentioned previously, the KP10 can be switched between two modes of operation; astandard A-BUS m

After holding both buttons down for a shortperiod, the second LED on the keypad will lightindicating that Bass adjust mode has beenactivated. In this

16 Incognito KP10 Note: This feature is only available if the KP10is part of a full Incognito multi-room system withone or two Local Input Modules (L

Incognito A-BUS keypad 17Continuing to hold Volume up and Power buttons will light LED 5, to indicate that Off mode isavailable for selection, and no

18 Incognito KP10 Input impedance 45 k ohmsFrequency response 20Hz – 20kHz +/- 1dBTHD <0.2% @ 1W, 20Hz – 20 kHzS/N ratio > 80 dB ‘A’ weighted

Incognito A-BUS keypad 19Cambridge Audio warrants this product to be free from defects in materials and workmanship (subject to the terms set forthbe

2 Incognito KP10 CONTENTSIntroduction...3System options...

Incognito KP10-EU www.cambridge-audio.comPart No. AP18303/2

Incognito A-BUS keypad 3Thank you for purchasing this Cambridge Audio Incognito product. Incognito is a cost-effective,modular based system using sta

The KP10 keypad can be used in two main configurations:1. As part of a full Incognito system, where it is plugged into an Incognito hub (AH10), perhap

Incognito A-BUS keypad 5Speaker cablePS10Speaker cableSS10 SS10AH10Cat-5/5e cableKP10-EU KP10-EUKP10 A-BUS keypad

A-BUS Ready / Incognito ReadyFor use with an A-BUS Ready/Incognito Ready unit (see diagram opposite) the Mode switchMUST be in the "Standard A-BU

Incognito A-BUS keypad 7Impedance 4 - 8 ohmsLoudspeaker TerminalsImportantPlease ensure that loudspeaker terminals are fully tightenedVeuillez s&apos

8 Incognito KP10 The KP10 is fitted on the wall by fixing it into a standard UK 47mm depth single-gangelectrician’s back-box (pattress). All knock-ou

Incognito A-BUS keypad 9Safety precautionsCare should be taken when choosing the site for a KP10, the keypad must never be installed in aback-box whi